The S1000RR is new on the market and revolutionizes the motorcycle-scene. We offer you carbon-parts which are approved by TÜV, namely ABE, as well as racing-products ✅ for the race track.The Numberplate Holder is made of high quality carbon fibre and covered with UV resistant clear lacquer. This licence tag holder has an ABE/street homologation. Due to the Side Panel Parts Street you gain not only a real motorsport look but also a non-negligible weight advantage because of the carbon fairing. The following listed products are usable with ABE for streets as well as race tracks.
The Rear Hugger is made of high quality carbon fibre and covered with UV resistant clear lacquer. It is available for bikes with and without ABS. The chain guard is connected to the Rear Hugger and this Rear Hugger is longer than the original one made out of plastic. Also the Front Fender is a visual highlight for your S1000RR. The Front Fairing, also called front mask, makes the sporty S 1000 RR special and remarkable. The Bellypan provides you safety on the road and on the racing track. You obtain a fancy design using the Tank Side Panel either for the left or right side or the Upper Tankcover. Both products are made of light in weight and high quality carbon fibre. The Swingarm Cover will be shipped as a pair for the left and the right side. You have to glue on the carbon fibre covers. We recommend silicon glue. The Clutch Cover and the Alternator Cover are very accommodating. The Heelguards will be also shipped as a pair for the left and the right side. The Frame Protection for both sides and the Ignition Rotor Cover are an absolute necessity for road or race track. The two parts for the tail, namely Tail upper part and Tail lower part, and the Airintake match your S1000RR perfectly.
We offer you a range of products but some are only adapted for the race track, for example the Bellypan Racing. The whole product is made of one piece and specially designed for the race track. It has no ABE/street homologation. If you want to use the original BMW pre-muffler, you need to cut out this bellypan a bit. The Racing Seat Unit is made of high quality carbon fibre and is specially made for the race track. You can order this seat with or without high quality powder coating. The Fairing Racing Set consists of 4 pieces. This set is also available with and without powder coating.The Front Fairing is made of high quality carbon fibre and covered with UV resistant clear lacquer. The whole product is made of one piece and specially designed for the race track. The Fairing Side Panels - Race Track are specially designed for the Race Track and have no homologation for street use. These fairings are availabe with and without turnsignalholder. Due to the Front Fairing Holder and the Instruments Holder you can lower the weight of your bike and reach necessary advantages in the race.
More precise information you can find in the detailed product descriptions.
