Rubber Grips for BMW K1100RS & K1100LT


All Bikes


Our rubber grips improve the rider's riding pleasure and safety. They reduce vibrations and have an outstanding material quality. They are resistant to weathering influences, UV and ozone.
Sold in pairs.
Length: 125-130 mm or 5 1/8"
Open-ended grip, compatible with handlebar ends.
Attention: Do you have heated grips or not?

The mounting of the rubber grips is not easy, especially on motorcycles with heated grips. In the event of improper handling, the heated grips can be damaged / cut through when removing the old rubber grips. This danger exists especially with fully glued rubber grips. The replacement of the rubber grips is at your own risk. We accept no liability for any damage to the motorcycle. If in doubt, please have the rubber grips replaced by a specialist workshop.


There is a video for this product - watch here!

Rubber Grips (Inner diameter 1x 22mm and 1x 24mm) (2 pieces)

Article-No. : 01690/F

Availability: immediately available    Show details
Price: € 28,90
USD: 30,68 $
GBP: 23,94 £
AUD: 46,84 $A

without VAT plus shipping

Rubber Grips for heated grips (Inner diameter 2x 24mm) (2 pieces)
When mounting, please make sure that you mount the rubber grips on the correct side (see labeling left/right on the rubber grips)!

Article-No. : 01690/F/24

Availability: immediately available    Show details
Price: € 29,90
USD: 31,74 $
GBP: 24,77 £
AUD: 48,46 $A

without VAT plus shipping

Questions about this article


How do I install the rubber grips when I have heated grips?
The installation is not easy. If you can't do it or have no experience in it, please go to a professional repair shop.
You have to cut the original grips from the heating.
Which is no big problem but you have to be careful!
Then you can put the new grips in boiling water to enlarge them.
Then of course dry them. Push them over the grip. That’s it.

Please make also sure that you order the correct grips.
You can find all sizes in the product description.
If you install too small grips they will of course crack!

Ratings

Rating:
The average rating of this product is 0 of 5:
(after 0 Ratings)
Rating
Make a new evaluation


Related / Recommended Products


Bump stop tank / seat

Bump stop for tank fixation /seat for BMW R1200GS...

Price € 6,80
without VAT plus shipping

Ignition cable set

This high-quality ignition lead set fits BMW K1100LT,...

Price € 79,90
without VAT plus shipping

Needle bearing

Needle bearing 10X32X17 If the rear wheel has too much...

Price € 82,90
without VAT plus shipping