Rubber Grips for Multi Controller for BMW K1600GT & K1600GTL

All Bikes

BMW K1600GT & K1600GTL Rubber Grips for Multi Controller

Our rubber grips improve the rider's riding pleasure and safety. They reduce vibrations and have an outstanding material quality. They are resistant to weathering influences, UV and ozone.

Part no. 02624/LN: plain surface
Length: 120-125mm (approx. 4 7/8 "), Hole diameter: 26-26mm

Part no. 01690/F/24N: Surface with grooves
Length: 125-130mm (approx. 5 1/8 "), Hole diameter: 26-26mm

For vehicles with Multi Controller (see image 3).

The mounting of the rubber grips is not easy, especially on motorcycles with heated grips. In the event of improper handling, the heated grips can be damaged / cut through when removing the old rubber grips. This danger exists especially with fully glued rubber grips. The replacement of the rubber grips is at your own risk. We accept no liability for any damage to the motorcycle. If in doubt, please have the rubber grips replaced by a specialist workshop.

There is a video for this product - watch here!

Rubber Grips with plain surface (2 pieces)

Article-No. : 02624/LN

Availability: immediately available Show details

Special price € 24,90
instead of € 28,90
USD: 25,88 $
GBP: 20,62 £
AUD: 41,54 $A
without VAT plus shipping

Rubber Grips with grooves (2 pieces)

Article-No. : 01690/F/24N

Availability: immediately available Show details

Special price € 27,90
instead of € 28,90
USD: 29,00 $
GBP: 23,10 £
AUD: 46,54 $A
without VAT plus shipping

Questions about this article

How do I install the rubber grips when I have heated grips?
The installation is not easy. If you can't do it or have no experience in it, please go to a professional repair shop.
You have to cut the original grips from the heating.
Which is no big problem but you have to be careful!
Then you can put the new grips in boiling water to enlarge them.
Then of course dry them. Push them over the grip. That’s it.

Please make also sure that you order the correct grips.
You can find all sizes in the product description.
If you install too small grips they will of course crack!

Ratings

Rating:
The average rating of this product is 4 of 5:
(after 1 Ratings)

JCD wrote | 2021-06-25:
This article exhibits a very good quality. As mentioned by Hörnig, these grips are not so easy to fit, however you do not need any specific skill but patience (especially for the removal of the former grips) 😉 The only slight imperfection inI found, is that these grips, although theh look nearly identical to th original, are actually suffering minor differences with respect to the OEM. In particular they do not have these little inner cutouts that allow a perfect fitting with the handle core. Yet, for the price and in the end the still very good fitting, I recommend this article !

Make a new evaluation